Lexicon DC-1 Manuel d'utilisateur télécharger pdf (Page 64)

DC-1 Version 4 Digital Controller

Troubleshooting

Routine Maintenance

Other than occasional replacement of the batteries in the remote control, the

DC-1 requires minimal maintenance. Use a soft, lint-free cloth slightly

dampened with warm water to clean the exterior surfaces of the unit.

Do not use alcohol, benzene or acetone-based cleaners

or any strong commercial cleaners.

Do not use abrasive materials such as steel wool or metal polish. If the unit

is exposed to a dusty environment, a low-pressure blower may be used to

remove dust from the DC-1 exterior.

Restoring Defaults

If severe power surges or sags cause problems with normal DC-1 operation,

or you simply want to start with a clean slate, you can restore all of the

factory defults with the following procedure.

This will erase any programs you have stored,

as well as all setup and calibration values.

Note any settings you want to re-use before proceeding.

Turn the DC-1 OFF with the remote. Turn the unit back ON and immedi-

ately press and hold MUTE on the remote. (Make sure you do not block the

infrared receiver on the DC-1 front panel.) The on-screen display will read:

FACTORY PRESETS MENU

EXIT

RESTORE DEFAULTS

If you want to resume normal operation without restoring all defaults, this

is your last chance. Use MENU ▲ or ▼ to highlight EXIT, then press

SELECT.

To restore defaults, use MENU ▲ or ▼ to highlight RESTORE DEFAULTS,

then press SELECT. This will clear and reload all preset effects and all

factory settings of Volume, Balance, Contrast, Configuration, etc.

When the message FACTORY DEFAULTS RESTORED is diplayed, press

DONE to return to normal operation. All of the adjustable parameters in the

DC-1 have now been reset to the values assigned when it cleared final

Quality Control at the factory.

If you cannot solve functional problems through these procedures, consult

your dealer or Lexicon Customer Service.

DO NOT OPEN THE UNIT.

DOING SO WILL VOID YOUR WARRANTY,

AND MODIFICATIONS MAY RENDER THE UNIT UNSERVICEABLE.

1 2 ... 59 60 61 62 63 64 65 66

Pas de commentaire

Lexicon DC-1 Manuel d'utilisateur Page 64